Download TWRP 3.0.2-0 tar for Galaxy Tab A 10.1 (WiFi/LTE)


Download and install Official TWRP recovery for Galaxy Tab A 10.1 by following the guide below. TeamWin officially released TWRP for multiple device where Galaxy Tab A 10.1 WiFi and Tab A 10.1 LTE variants also gifted with the official TWRP 3.0.2-0 builds. TWRP recovery for Samsung devices is flashable mostly via Odin, we have already posted similar guide for other devices. TWRP is a choice of millions of users who perform multiple operation including flashing custom ROMs, backup and much more.

TWRP recovery has a User friendly interface and convenient to use even for the beginners. If you are an experienced user then well & good, you will never find any confusion in the installation process but if you are new to the flashing process then you have to pay full attention on the step by step guide to successfully install TWRP recovery on your Galaxy Tab A 10.1 (WiFi/LTE).

How to install TWRP recovery on Galaxy Tab A 10.1 (WiFi/LTE)

Before you begin:

Disclaimer: This tutorial includes flashing custom recovery process. Follow the guide on your own risk, we are not responsible if you brick or damage your device however the chances of bricking a device are rare but you have to pay full attention on the complete guide to avoid any issues and difficulties while performing any of the above mentioned operation.

Enable USB Debugging (Settings >> Developer Options >> USB debugging)

Your phone battery should be charged minimum 80%

Download Odin 3.10.6

Download Samsung USB drivers

Process to install TWRP Recovery on Galaxy Tab A 10.1 (WiFi/LTE)

Just follow the below steps in sequence to install TWRP recovery on your Galaxy Tab A 10.1 (WiFi/LTE).

Click Odin.exe to run the Odin tool.

Now boot your device into Download Mode, to do so turn off your device properly and turn it on again by pressing and holding Home Button + Volume Down + Power Key simultaneously until you see a warning now press Volume up to enter Download Mode.

Connect your device to PC via USB cable.

If everything goes well Odin will detect your device and the ID:COM box should turn blue which indicates that your device has been successfully added.

Please make sure “Auto Reboot & F.Reset Time” options are checked in the Options Tab in Odin screen.

Once the above process is done now again in Odin click the AP tab and select the downloaded TWRP recovery file for your device.

Hit the start button at the bottom and wait for the installation process to complete.


Once the process is completed you will see a “PASS” message in the ID:COM box.

Your device will automatically reboot and disconnect the device.

TWRP recovery has been successfully installed in your device.


You can also make Nandroid backup of your device. (It’s optional for data and system safety)

Download TWRP for Galaxy Tab A 10.1 WiFi [gtanotexlwifi]

Download TWRP for Galaxy Tab A 10.1 LTE [gtanotexllte]

That’s it! You have successfully installed TWRP recovery on your Samsung Galaxy Tab A 10.1 (WiFi/LTE) on latest firmware . If you have any query feel free to contact us by posting your comment in the below provided comment section.

A Software Engineer who loves to hang around latest gadgets and writes his own experiences to get the best possible and accurate information.

We will be happy to hear your thoughts

Leave a reply